reference circuit

Firstly the sub-blocks including bias circuit, bandgap reference, and voltage regulator circuit are introduced, and then the temperature coefficient adjustment of voltage generated by bandgap reference is analyzed.

介绍了该电路的各子模块电路，包括偏置电路、带隙基准电路和输出电压调节电路，详细分析了带隙基准电路所产生的基准电压的温度系数及其调节原理。

Design of a High-accuracy Current Reference Circuit with Band Gap Configuration

一种采用带隙结构的高精度电流基准电路设计

A low voltage current mode bandgap voltage reference circuit with a novel start-up circuit is designed.

介绍了一种低压电流模带隙电压基准电路,并提出了一种新颖的启动电路结构.

The pulses of rotate speed, reference of phase and tracking central frequency of filters are provided by reference circuit.

不平衡信号处理部分由基准信号电路和振动信号电路组成。基准信号电路用于测量转速、为测量相位提供基准以及为带通滤波器的中心频率提供跟踪脉冲。

Design of low temperature drift bandgap voltage reference and driving circuit

低温漂带隙基准源及驱动电路设计

The designed LDO circuit include bandgap reference, thermal protect circuit, limit current circuit, fast turn on circuit.

本文设计的LDO电路还包含带隙基准源，过温保护电路，限流电路，快速启动电路。

Design and Research of the Reference Circuit in Magnetic Card Decoder Chip

磁卡解码芯片中基准电路的设计研究

Reference circuit is a vital basic module in the analog IC design, and it includes voltage and current reference.

基准电路是模拟电路设计中的一个关键的基本模块，它包括基准电压源和基准电流源。

The power detection circuit using the logarithmic detector is designed, which is used to measure the microwave power of test channel and reference channel. So that the resonance curve of the resonant cavity can be figured by means of the detection data.

采用射频对数检波器设计了功率检测电路，用于检测测试通道和参考通道的微波功率，从而测得微波谐振腔的谐振曲线。

A new non-bandgap CMOS voltage reference circuit with compensation of thermal voltage V_T and threshold voltage V_ th is proposed in this paper.

提出了一种基于阈值电压Vth与热电压VT相互补偿的新型非带隙CMOS电压基准源。

Typical sub-blocks were analysed emphatically such as Switch Capacitor Sampling/ Holding Block, Brightness Control Block, Oscillator, Thermal Shut Down Circuit, PTAT and Bandgap Reference etc.

重点分析了典型子电路模块：开关电容采样保持电路、亮度控制电路、振荡器、过温保护电路、PTAT和带隙基准电路等。

The ADC core area is 2.0 mm 2 without band-gap and reference circuit.

整个ADC芯片 内核面积2.0平方毫米(不包括参考电压产生电路).

Peaking Current Mirror-Biasing Reference Circuit Working in Subthreshold Region

工作于亚阈值区的偏置基准电路-峰值电流镜

This paper introduces a supply voltage band-gap reference circuit which used a self-bias cascode current mirror.

因此介绍了一种采用自偏置低压共源共栅电流源的带隙基准电路结构,用两个电阻代替了偏置电路.

The circuit breaker current status got by the data acquisition board can also be by wireless transmission to a wireless terminal, the operator can be obtained from the terminal display about the circuit breaker. Of course, these states can be reference for judging circuit breaker status.

数据采集板分析得到的断路器当前状态也可以通过无线传输给无线显示终端，操作员可以从终端的显示屏上得到断路器当然各机构的工作状态，这些状态可以为判断断路器状态提供参考。

The Research and Design of a Curvature Compensation Bandgap Reference with Thermal Protection Circuit

带曲率补偿的带隙基准及过温保护电路研究与设计

Based on the analysis, a frequency and phase stabilized two-phase sinusoidal power clock generator is proposed, which, while connected to an external reference clock, makes the oscillating circuit in synchronization with the reference clock.

在此基础上，提出了稳定功率时钟频率与相位的功率时钟产生电路，即接入外部参考时钟，使振荡电路与参考时钟同步。